Maxx Ice MCWC28-O Use and Care Manual download pdf (Page 9)

Cellar does not turn on

Not plugged in. Fuse blown or circuit breaker tripped.

Noise or vibration

Check that unit is level. If not, adjust leveling legs.

Cellar is too warm

Check that door is properly closed and sealed. Check temperature setting. (To

change the temperature setting, follow the steps in the Operating Your Wine Cellar

section of this manual.) Check if door has been opened frequently.

LCD displays “PROBE ERROR - E”

This message is an ALARM MODE indication. The LCD displays “PROBE ERROR” on the

left and “E” in the middle when the thermostatic sensor has malfunctioned. When this

happens, the cellar first stops working for 15 minutes, then turns ON for 5 minutes and

OFF for 15 minutes automatically and continuously. Contact your authorized service

facility for sensor replacement.

LCD displays “LOW TEMP”

This message is an ALARM MODE indication. The LCD displays “LOW TEMP ” on the left

and the actual temperature reading in the middle. It indicates that the actual tem-

perature is much lower than your set temperature and that the magnet valve may

not be functioning properly and should be replaced.

LCD displays “HIGH TEMP”

This message is an ALARM MODE indication. The LCD displays “HIGH TEMP ” on the

left and the actual temperature reading in the middle. It indicates that the actual

temperature is much higher than your set temperature. Possible causes are:

N The door might not be fully closed.

N Requires service.

N The control panel may not be functioning properly and should be replaced. If you

are certain that the door is not the cause of the problem, contact your authorized

service facility immediately.

CELLAR TROUBLESHOOTING

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Maxx Ice MCWC28-O Use and Care Manual Page 9